12V10A电源适配器
产品优点
·全球适用AC输入电压
· 软启动电流、有效降低AC输入冲击
· 有短路保护、过载保护
· 100%满负荷烧机测试
输入特性
2.1输入电压
2.2输入频率
额定频率(Nominal Frequency):50/60Hz
调整频率(Variation Frequency):47-63Hz
2.3输入电流
当输入交流电压为额定值的下限时,输出电压负载满载,最大输入交流电流2A。
2Arms max At any input voltage and rated, DC output rated load.
2.4浪涌电流
15Amps Max. Cold start at 240Vac input, with rated load and 25℃ambient.
2.5 AC漏电流
当输入电压240Vac时,最大漏电流为0.25mA。
0.25mA Max At 240Vac input.
输出特性
3.1输出功率
电压(+12Vdc) 最小负载( 0A ) 最大负载(10A ) 峰值功率(15A ) 输出功率( 120W)
3.2负载特性/调整率
电压(+12Vdc) 最小空载电压(12.0V) 最大空载电压(12.6V) 线性调整( ±3% ) 负载调整( ±5%)
3.3波纹和噪音
The ripple and noise are as follows when measure with Max. Bandwidth of 20MHz and Parallel 47uF/0.1uF,crossed connected at testing point.
电压 最大波纹最大噪音
Voltage Ripple And Noise(Max.)
+12.0Vdc100mVp-p
当输入115Vac和输出最大负载时,最大启动时间为2S。
2 second Max. At 115Vac input and output Max. Load.
3.5上升时间
当输入115Vac和输出最大负载时最大时间为40mS。
40mS Max. At 115Vac input and output Max. Load.
3.6保持时间
当输入115V和输出最大负载时,最小保持时间为5mS。
5mS Min. At 115Vac input and output Max. Load.
3.7效率
当输入100Vac和输出最大负载时,最小80%。
80% 100Vac input and output Max. Load.
当输入240Vac和输出最大负载时,最小85%。
85% 240Vac input and output Max. Load.
3.8过沖
15%Max.When power supply at turn on or turn off
保护功能
4.1短路电路保护:
该电源供给器在短路解除时,能正常工作恢复。
The power supply will be auto recovered when short circuit faults remove.
4.2过流保护
The power supply will be auto recovered when over current faults remove.
4.3过压保护
当输出电压超过额定电压时,电源将保护,故障排除后能恢复正常工作。
The power supply will not be auto recovered when faults remove.
环境要求
5.1工作温度
0℃~ -40℃,满载,正常工作(Full load Normal operation)。
0℃to40℃,Full load Normal operation.
5.2储存温度
-20℃to85℃,带外壳(With package).
5.3工作湿度
5%(0℃)~90%(40℃),72小时,满载,正常工作
5%(0℃)~90%(40℃)RH,72Hrs,Full load Normal operating.
5.4振动
1、测试标準:国际工电子委电员会 Operating: IEC 721-3-3 3M3 5~9Hz,A=1.5mm 加速度(9~200Hz,Acceleration 5m/s2) 2、运输(Transportation): IEC 721-3-2 2M2
5-9Hz,A=3.5mm
9~200Hz,加速度Acceleration=5m/S2
200~500HZ,加速度Acceleration=15m/S2
3、轴向振动(Axes,10 cycles per axis).
No permanent damage may occur during testing.
在电源开启和关闭后,样机能够恢复到最初条件。
The product has to restors its original situation after power off/on.)
5.5跌落试验
一个角,三个棱, 六个面。
高度76m Height:76cm
安全及要求
6.1安全
:过CE UL GS PSE FCC ROHS SAA认证.
6.2高压
Primary to secondary)3000Vac/5mA/60s.
结构参数
外壳
外壳尺寸: 171*71*40mm
The power supply size :171*71*40mm
输出线
DC cable: AWM 2464 24AWG*2C,80℃,FT1,300V,with word on
the cord,Length:1.5M, withOUT magnetic ring, 四芯航空头
铭牌
白底黑字
black words with white background
材质:PVC
Material: PVC
耐高温110度以上
Endure heat above110℃
厚度0.2-0.3mm
Thickness:0.2-0.3mm
3*RI±0.1mm
3*RI±0.1mm
斜角2.5mm
Angle 2.5mm
本文由'糜涤'发布,不代表演示站立场,转载/删除联系作者,如需删除请-> 关于侵权处理说明。